ID: 22263587
Atnaujintas prieš 10 val.
39622_ / 472
1.19 %

Audio-technica At899 kondensatorinis mikrofonas

Idelaus mikrofonas balsui

Nei karto nepanaudotas
Gausus ir pilnas komplektas
Papildomas priedas: “Rycote “kailiukas vejo triuksmui slopinti
Gali dirbti su autonominiu Phantom energijos saltiniu (yra komplekte AT-8537)

Transducer - Fixed-charge plate, permanently polarized condenser
Polar Pattern - Omnidirectional

Frequency Response - 20-20,000Hz

Dynamic Range (Typical) Phantom: 108dB, 1kHz at Max SPL
Battery: 86dB, 1kHz at Max SPL

Signal-to-Noise Ratio - 64dB, 1kHz at 1Pa

Maximum Input Sound Level
Phantom: 138dB SPL, 1kHz at 1% THD
Battery: 116dB SPL, 1kHz at 1% THD

Power Requirements
Phantom: 11-52V DC, 2mA typical
Battery: 1.5V AA/UM3

Output Impedance
Phantom: 200 ohms
Battery: 250 ohms

Output Connectors - Mic Cable: TA3F output

Power Module: Balanced 3-pin XLR
Pad No

Microphone: 0.63 x 0.20" (16.0 x 5.0mm) (Length x Diameter)
Power Module: 5.71 x 0.83" (145 x 21.0mm)(Length x Diameter)

Microphone: 0.02oz (0.5g)
Power Module: 3.6oz (102g)

Maximum intelligibility and clean, accurate reproduction for vocalists, lecturers, stage and television talent, and worship leaders
Low-profile design (a mere 5 mm in diameter) is ideal for applications requiring minimum visibility
Includes an extensive array of accessories
Switchable low-frequency roll-off reduces sensitivity to popping in close vocal use
Operates on battery or phantom power
The AT899 is designed to be worn as a lavalier or hidden in loose clothing or in the hair. For use as a lavalier, attach the microphone about six inches below the chin. Anticipate movements that may cause the microphone to rub against or be covered by clothing, and position the microphone to avoid it.
The included single and double mic holders are interchangeable with all the bases. To change the holders, simply remove original holder and snap in the desired one. When using the AT899 in extremely close situations, slip the included open-pore foam windscreen over the mic to reduce wind noise or “popping. Use the included element cover to protect the microphone element from contaminants.
CAUTION! To avoid possible injury, use caution when affixing the AT899 viper clip to clothing. The pins are sharp and may puncture skin. For best results, ensure that pin ends rest on outside of clothing.
The AT899 requires 11-52V DC phantom power, or a 1.5V AA battery for operation. A battery need not be in place for phantom power operation.
Battery installation: Unscrew the base of the power supply unit and insert one AA battery into the battery compartment, being certain to observe battery polarity as marked. Then simply screw the base shut. Alkaline batteries are recommended for longest life. Remove the battery during long-term storage.
Output from the power modules XLRM-type connector is low impedance (Lo-Z) balanced. The signal appears across Pins 2 and 3 Pin 1 is ground (shield). Output phase is “Pin 2 hot – positive acoustic pressure produces positive voltage at Pin 2.
The microphone is RoHS compliant–free from all substances specified in the EU directive on hazardous substances.
Avoid leaving the microphone in the open sun or in areas where temperatures exceed 43 C (110 F)

Kaina: 249 €

Visi pardavėjo skelbimai:
Susisiekti el. paštu
El. paštas:
Siūloma kaina:
Nebūtina pildyti
Paskutiniai komentarai
Jūsų vardas

Nusiųsk skelbimą draugui

Jūsų draugas gaus įdomaus ar aktualaus skelbimo nuorodą el. paštu arba SMS žinute
Jūsų el. paštas:
Draugo el. paštas:

Informavimas apie netinkamą skelbimą administracija gaus pranešimą apie netinkamo turinio skelbimą
Jūsų komentaras

Redaguoti skelbimą

Jei nori redaguoti skelbimą, prisijunk prie šio skelbimo vartotojo paskyros.
Prisijungimo vardas:
Pamiršote prisijungimus?

Jei nori redaguoti skelbimą, prisijunk prie šio skelbimo vartotojo paskyros.
Prisijungimo vardas:
Pamiršote prisijungimus?